The NextGen Simulations EMB-110 Bandeirante features TDS GTNXi for the GTN750Xi in the Virtual Cockpit!

Selection of the TDS GTNXi can be performed from the EMB-110s EFB (Electronic Flight Bag / virtual tablet)

More information and to purchase the NextGen Simulations EMB-110 Bandeirante can be found here:
https://www.nextgensim.com.co/Products/E110MSFS

I did a re-install of MSFS 2020 and now my TDS GTN 750xi is not working. When I go into the TDS offline it powers up just fine. It however shows a black screen in all my aircraft. Does anyone have any suggestions that might get it working again. Thanks for your help guys!

When I start the TDS sim software my 750 and 650 appear on my RSG units in a non full screen mode. I always have to maximize them in the top right hand corner and even then the white window bar does not disappear.

Is there a way to get it full screen, no window bar and remember that position every start up?

To get my 650 full screen is a nightmare, the cursor is tiny..

Dave

Ok, I have tried to look in the manual, and I am a pilot but not an IT guy.

First, how do I make GTNXi capture the altitude set in the aircraft altitude window.  In several initial tries, the airplane just doesn't capture the altitude.  Sort of like the old 737 100s.

The other question is how do I get it to do VNAV?  VNAV shows a top of descent point, but though I dial in a lower altitude in the window and then select VS on the King Air, the aircraft doesn't start down.  Please point me to the instructions.

hello, I installed the program as indicated in the tutorials but I see that all aircraft equipped with the GTN 750/ xi version does not work.

I looked at several topics on the forum none solved my problem, I have windows defender on windows 10. I first delete all mods on the market of microsoft flight simulator concerning avionic. I made all the updates of the TDS GTNXI flight sim/ PC trainer and Garmin programs.

However I still have a black screen problem on all aircraft equipped with GTN 750/750xi.
The TDS GTNxi flight sim is connected to msfs, when I launch it before msfs I see the avionic with my license but when I make my flight the program disappear. I restart it and it is in "gauge mode" but still black screen in the plane.

Thank you for reading me and I hope we can find a solution to my problem.

Hi, I've got a few questions.

In Timers, it appears that the function that records take-off time records the local time of my PC instead of in the timezone of my aircraft. Can I change this?

How do I calculate a TOD and have it show up? Sometimes I see it and sometimes I don't. I know VNAV isn't supported (really hoping this will change) but can a TOD be calculated with just the descent angle?

Does the Glass Cockpit Refresh Rate setting in MSFS affect the framerate of the GTN in the VC? If not, what does?

I know it's not high on the priority list, but will music support be considered?

This is a massive stretch, but since the product is presumably a utility that links Garmin Trainer to MSFS, will other products be considered? There's a massive lack of quality glass cockpit avionics for GA in MSFS so I think for example G500/600 TXi would be awesome and would go really well with the 750/650 Xi. 

Thanks!

I am getting this error while installing. Not sure what to do. It has been a while on this error and I just cannot figure it out. I am starting the manager as admin too.

Attached Files

Thumbnail(s)
   

Hi, when flying the Comanche 250 MSFS (other affected airframes are VANS RV14 and 10) The aircraft Continuously rocks left to right and will increase in intensity over time when the autopilot is engaged via GPS mode, does not happen in Heading mode. When I switch to the GNS 530 it will instantly stop or when a new flight is started with any other GPS other than the 750.

Hi there,
I recently purchased this GPS for the A2A Comanche. At the moment I am flying to KPDK. I wanted to fly the RNAV for rwy 3R, which has a nice curved segment, but I cannot find it among the approaches. The interesting part is that it shows up in the charts within the GTNXi itself, so the database knows about it.

I also checked Midway and the situation is the same. The approaches containing curved segments are not available, but are on the charts. The product page says this GPS is capable of flying such procedures, so I must be missing something. 

Is there some kind of setting that I need to switch on somewhere?

Other than this issue, the GTNXi is fantastic. Keep up the good work!

Regards,
Fabrizio

Hi I have ran TDSGPSManager.exe and it has installed the PC Trainer. However when I try to install the Flight Simulator I receive a message to say it has detected a double installation of MSFS both Steam and Microsoft Store. I respond with 'Yes' to accept Microsoft Store installation - which is what I have. The installation of version 1.0.2.7 then starts but then fails to install. See attachment.

I was wanting to unistall TDSGPSmanager and try a fresh install but there doesn't seem to be a way to do that!

Any help would be appreciated. Thanks

Attached Files

Thumbnail(s)