Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Glide Slope conflict with GTN 650 and Onboard Garmin
#1
Hi Folks, I'm a super basic user here and was wondering if someone can break this down into simple pieces for me:
I have a RealSimGear GTN 650 with the TDS Software running on FS2020. I just use the standard Asobo, non G1000 Cessna. 

It appears that my CDI is being fought over between the onboard unit and my TDS input. My expectation is that when I select the source in the TDS software, it should handle this and know what to do.

It sounds from similar posts that I can somehow disable the input from the onboard GPS. What is the easiest way to do this?
Thank you so much!

-Mike
Reply
#2
Hello Mike,

Sure, it is possible to use the TDS GTNXi with the default C172, but for this you must disable the WT GNS 530/430 :

By setting these LVars to 1 when using the TDS GTNXi:
L: XMLVAR_GPS_DISABLED_AS530_1
L: XMLVAR_GPS_DISABLED_AS430_1

You can use Spad.Next to set the Lvars

Or you can refer to this article:
https://www.fsdeveloper.com/forum/thread...lt.454423/

In addition, you can permanently disable the GNS units by commenting the panel.cfg of the C172, but we do not advise this.

Please enjoy the TDS GTNXi!
Reply
#3
Thank you for the quick reply! So searching all .flt files on my system, I have almost 2k of them. Which FLT file should I be editing? Thanks!
Reply
#4
It should be the FLT flight of the current flight, or even better, you can save a special flight for this exact scenario!

In addition, you can search on Google for other options on setting LVars.
Reply
#5
Ok, thank you for the info so far. I'm making progress. I created a new flight and saved it. Then I edited the FLT file as shown in the attached screenshot. After re-running FS2020 and launching that flight, doesn't seem to be any change. Any idea what I did wrong?

Thank you again,
Mike


Attached Files Thumbnail(s)
   
Reply
#6
Hello, you forgot to set them as 1 by adding =1 at the end, as all the variables above.
Reply
#7
It worked!!! Thank you so much! I can finally practice approaches which will be so helpful in my IFR training.

-Mike
Reply
#8
Hello Mike,

We are glad to hear this, please enjoy the TDS GTNXi!
Reply


Forum Jump:


Users browsing this thread: 4 Guest(s)