This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
TDS Sim Software Forums › TDS Sim Software › TDS GTNXi Flight Simulator v
No VC for GTN 750 in Piper Arrow!!!

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
No VC for GTN 750 in Piper Arrow!!!
nilocselab Offline
Junior Member
**
Posts: 4
Threads: 4
Joined: Mar 2022
Reputation: 0
#1
04-01-2022, 07:43 PM
Hello

I have just purchased the PA-28R Turbo Arrow 111/1V from MSFS marketplace but I don't have the GTN 740 showing in my aircraft. I just have the normal NAV stuff.

Please help.

Regards

Colin
Find
Reply
adminOwner2 Offline
Administrator
*******
Posts: 1,558
Threads: 37
Joined: May 2017
Reputation: 1
#2
04-01-2022, 08:21 PM
Hello Colin,

The selection of the TDS GTNXI is done through the virtual tablet located on the copilot's side, by changing the GPS Source. The Just Flight Pipers purchased from the MSFS Marketplace have been updated to support the TDS GTNXi as a configuration. Upon first load, it takes about 3 minutes for MSFS to compile the WASM gauge, after which the selection should appear.
This procedure is also described in the Just Flight Piper manual. Please try this and let us know how it goes.
Find
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)