Auto Pilot broken with TDS GTNXi running

[Larry J]

Hello to all,

Thanks in advance for reading this.  Days I have searched with no joy.  I have the GTNXi software running on a separate monitor, not in the VC.  Running MSFS 2020, default C-172 Steam Gauges, stock up to date WT-430 and 530.

My stock KAP140 autopilot is broken.  Specifically the display shows the AP engaged, but no ROL, HDG, ALT or other displayed values.  If I cycle off the AP, then back on, it briefly flashes ROL and then goes dark again. 

If I do not run the GTNXi software, all is well.  Please see attached photos.

I have tried changing the Navigation setting from Simulator to 650 to 750 with no changes.

I do hope someone can help.

Thanks again.

[adminOwner2]

Hello,

This post is related to a recent one with the same issue, please continue the discussion here:
http://forum.tdssim.com/thread-1017.html