Hello to all,
Thanks in advance for reading this. Days I have searched with no joy. I have the GTNXi software running on a separate monitor, not in the VC. Running MSFS 2020, default C-172 Steam Gauges, stock up to date WT-430 and 530.
My stock KAP140 autopilot is broken. Specifically the display shows the AP engaged, but no ROL, HDG, ALT or other displayed values. If I cycle off the AP, then back on, it briefly flashes ROL and then goes dark again.
If I do not run the GTNXi software, all is well. Please see attached photos.
I have tried changing the Navigation setting from Simulator to 650 to 750 with no changes.
I do hope someone can help.
Thanks again.
Thanks in advance for reading this. Days I have searched with no joy. I have the GTNXi software running on a separate monitor, not in the VC. Running MSFS 2020, default C-172 Steam Gauges, stock up to date WT-430 and 530.
My stock KAP140 autopilot is broken. Specifically the display shows the AP engaged, but no ROL, HDG, ALT or other displayed values. If I cycle off the AP, then back on, it briefly flashes ROL and then goes dark again.
If I do not run the GTNXi software, all is well. Please see attached photos.
I have tried changing the Navigation setting from Simulator to 650 to 750 with no changes.
I do hope someone can help.
Thanks again.