(01-17-2024, 03:20 PM)adminOwner2 Wrote: Hello,
To resolve the TAWS errors, please change the TDS GTNXi Interface, Settings tab from TAWS-A to TAWS-B.
In addition, which aircraft are you using to test in MSFS as a VC integrated?
Does the TDS GTNXi enter in "gauge mode" (as shown in the TDS GTNXi Interface when inside MSFS and with the aircraft loaded).
In addition, do you have the MSFS Community folder WASM gauge: tds-gtnxi-gauge ? Please make sure to reinstall the
Not to worry, we will resolve this issue, we always do!
Thanks for the fast response. I am presently trying to link it to the caranedo products, but I also use the A2A Commanche and other single engine and turbo props. It used to work across the board of airplanes I use, but now it still doesn't seem to be recognized now. I switched the settings to TAWS B, which fixed the failure I had been receiving, but the last message may have been cut off in regard to the reinstall. I have no idea what the WASM gauge is so I likely do not have it. I feel as if I am close to making it connect but not quite there yet.