01-05-2024, 07:06 PM
Hi Folks, I'm a super basic user here and was wondering if someone can break this down into simple pieces for me:
I have a RealSimGear GTN 650 with the TDS Software running on FS2020. I just use the standard Asobo, non G1000 Cessna.
It appears that my CDI is being fought over between the onboard unit and my TDS input. My expectation is that when I select the source in the TDS software, it should handle this and know what to do.
It sounds from similar posts that I can somehow disable the input from the onboard GPS. What is the easiest way to do this?
Thank you so much!
-Mike
I have a RealSimGear GTN 650 with the TDS Software running on FS2020. I just use the standard Asobo, non G1000 Cessna.
It appears that my CDI is being fought over between the onboard unit and my TDS input. My expectation is that when I select the source in the TDS software, it should handle this and know what to do.
It sounds from similar posts that I can somehow disable the input from the onboard GPS. What is the easiest way to do this?
Thank you so much!
-Mike