09-12-2023, 08:22 PM
Background info: i9 12900 CPU 3080 GPU 32 GB ram Quest 2 VR headset, Corsair Scimitar RGB Elite gaming mouse, USB Num Pad.
The 12 mouse side buttons are programmed with macros to move between the instrument views in the BlackSquare Kingair Analogue cockpit. I have purchased the TDS GTNxi 750, installed it, and it works perfectly.
Here's the issue. With the VR headset on, I use the numpad to respond to ATC. If the blue highlighter on the TDS GTNxi 750 panel is active on the comm or nav radio boxes, the numpad responses don't work. The little highlighter has to be located at the bottom of the screen (on map flt pln traffic) for the numpad responses to work. This means that when I change comm or nav frequencies, I have to use the "push" function on the little control knob (bottom right) to move the highlighter back down to the bottom of the panel to acknowledge directions given by ATC.
I don't know this for sure, but I would imagine that the mic button on the yoke in a real Kingair would work regardless of where the little highlighter is sitting.
Any ideas?
JIm
The 12 mouse side buttons are programmed with macros to move between the instrument views in the BlackSquare Kingair Analogue cockpit. I have purchased the TDS GTNxi 750, installed it, and it works perfectly.
Here's the issue. With the VR headset on, I use the numpad to respond to ATC. If the blue highlighter on the TDS GTNxi 750 panel is active on the comm or nav radio boxes, the numpad responses don't work. The little highlighter has to be located at the bottom of the screen (on map flt pln traffic) for the numpad responses to work. This means that when I change comm or nav frequencies, I have to use the "push" function on the little control knob (bottom right) to move the highlighter back down to the bottom of the panel to acknowledge directions given by ATC.
I don't know this for sure, but I would imagine that the mic button on the yoke in a real Kingair would work regardless of where the little highlighter is sitting.
Any ideas?
JIm