02-08-2023, 06:32 PM
(This post was last modified: 02-09-2023, 08:28 PM by plferguson.)
(02-08-2023, 12:46 PM)adminOwner2 Wrote: The TDS GTNXi should set the MSFS default HSI GSI variable, with which aircraft are you encountering this problem? Maybe it is not set up to use the correct and supported variable?
All of the above testing has been on the ASOBO c172 Skyhawk with 430 and 530 gps. I tested the system with an approach that is "RNAV LPV into CMH" and the G5 do NOT give me a magenta Glide Path Indication.
Please note that the CDI report the Glide path, however, Air Manager's G5's do not! I did some research and this may be an Air Manager Issue that has not been fixed but I'm not sure.
Can you explain why I'm not getting the Glide Path?
Also, I tested the setup with the ASOBO c172 Skyhawk G1000 gps and the hsi/cdi was toggling back and forth. A few questions on this one:
1. I download SPAD and set it up so I could set those variables as you stated earlier. It does work very well.
1a. Should TDS software set these variable for me?
1b. Before I spend money on SPA, is SPAD the best solution?
2. Do you need to disable the G1000?
2a. If so what are the variables?
3. I prefer to fly aircraft with the RSG GTNxi650 hardware and is that possible on all aircraft?