06-12-2021, 11:26 PM
Hi Les,
My gtn750 uses flight1tech standalone software, which can be mapped with keystrokes. But there are no news about flight1tech and MSFS migration.
My gtn750 bezel is 3d printed and I use an arduino pro micro which reads the physical buttons and knobs and send keystrokes to g750 software. Works great.
I have purchased the tds gtn750 now, and works fine (some problems with GPS mode and HSI needles I think, but works fine and really smooth. I hope Asobo fix these problems in future). I will wait for the keys/joystick buttons functionality, and MSFS A2A planes to migrate my cockpit to MSFS.
Arturo.
My gtn750 uses flight1tech standalone software, which can be mapped with keystrokes. But there are no news about flight1tech and MSFS migration.
My gtn750 bezel is 3d printed and I use an arduino pro micro which reads the physical buttons and knobs and send keystrokes to g750 software. Works great.
I have purchased the tds gtn750 now, and works fine (some problems with GPS mode and HSI needles I think, but works fine and really smooth. I hope Asobo fix these problems in future). I will wait for the keys/joystick buttons functionality, and MSFS A2A planes to migrate my cockpit to MSFS.
Arturo.