05-22-2022, 02:19 PM
Hi,
I have attempted several installs/deletes and reinstalls now and they have all resulted in the same failure point listed above with the Garmin Trainer installation. Could you share the workaround for this issue?
I have previously used Flight 1 GTN products as well as their G500 on an FSX and P3D install. I did deleted the old copy of the trainer and the F1 products associated with it but the install is still failing at the offline trainer part with greyed out switch to proceed. I am concerned there are still some old remainates of those installations messing things up.
I will change the destination folders for the install and system files after trying to purge any other older files that might be contributing to this issue while I wait for a reply.
When the installation finishes, is there a requirement to open the trainer and run it (once) before it's functional or can it be closed once the dialogue displays?
System is an i7 with 32GB Ram 3x2TB HDDs' and using a GTX1080Ti running Windows 10. I'm displaying the GTNs' on a separate 9" touchscreen monitor in portrait 768x1024 in a custom 3d printed fascia (Both 750 and 650 displayed in a stack) with switches and encoders I had made for the older software.
Many thanks,
Stuart
I have attempted several installs/deletes and reinstalls now and they have all resulted in the same failure point listed above with the Garmin Trainer installation. Could you share the workaround for this issue?
I have previously used Flight 1 GTN products as well as their G500 on an FSX and P3D install. I did deleted the old copy of the trainer and the F1 products associated with it but the install is still failing at the offline trainer part with greyed out switch to proceed. I am concerned there are still some old remainates of those installations messing things up.
I will change the destination folders for the install and system files after trying to purge any other older files that might be contributing to this issue while I wait for a reply.
When the installation finishes, is there a requirement to open the trainer and run it (once) before it's functional or can it be closed once the dialogue displays?
System is an i7 with 32GB Ram 3x2TB HDDs' and using a GTX1080Ti running Windows 10. I'm displaying the GTNs' on a separate 9" touchscreen monitor in portrait 768x1024 in a custom 3d printed fascia (Both 750 and 650 displayed in a stack) with switches and encoders I had made for the older software.
Many thanks,
Stuart