This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Hi guys,

I have RSG 750 and 650 hardware units...

When I tune the ATIS into the standby on the 650 I can transfer it to the active fine, however within about 2 seconds it automatically switches back to standby.

I have Com 2 monitored on the 750 and in the settings for the 650 set to Com2/Nav2

Thank you...

Which version of the TDS GTNXi are you running?
It was 1.04.01 but have just updated to the latest version so will test that.

Forum Jump:

Users browsing this thread: 1 Guest(s)