This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Start up
#1
New Feature - Electrical Circuit Support - the TDS GTNXi can be attached to specific electrical circuits for aircraft that support this feature (HPG H145, SWS RV-10)

Given the above new feature in the most recent release does this suggest the 750 will remain blank until the avionics switch is turned on as that would be excellent..

Developers could implement it..

Dave
Reply
#2
Hello Dave,

We are not sure what you are asking us in this message?
Reply
#3
At present when I open your software I have the 750 loaded on my second monitor.
Before I have even powered up the plane.


Technically it should only come on when powered up by the avionics switch...is that what has been implemented?

Dave
Reply
#4
No, this function is pertaining to gauge mode and the electrical system of each aircraft.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)