+- TDS Sim Software Forums (http://www.forum.tdssim.com)
+-- Forum: TDS Sim Software (http://www.forum.tdssim.com/forum-1.html)
+--- Forum: TDS GTNXi XPlane (http://www.forum.tdssim.com/forum-3.html)
+--- Thread: 1.0.0.2 blank screens on GTNs - Solved (/thread-1439.html)
1.0.0.2 blank screens on GTNs - Solved - Dakota - 03-15-2025
I applied the 1.0.0.2 update this afternoon, and upon restarting I was greeted with empty black screens on the GTNs. Nothing else changed, I had been flying just minutes before.
Solution: Go to your ...X-Plane 12\Resources\plugins folder and you'll now see two similar sub-folders: TDS-GTNXi with an older date and TDSGTNXi with today's date or when you updated to 1.0.0.2. The later one is correct, and the TDS-GTNXi (with the hyphen) is a fossil from the older version. Delete it, leaving only the TDSGTNXi folder. Stop and restart X-Plane. You should now see the normal startup screen in the two GTN units.
After doing this I had a problem where as soon as clicked Continue, the #1 unit started flashing between screens and would not start up. I was able to start the #2 unit normally. Then I killed X-Plane again and restarted. This time both units started normally and as far as I can tell all is OK.
RE: 1.0.0.2 blank screens on GTNs - Solved - adminOwner2 - 03-15-2025
Hello,
Most likely a process was stuck open, perhaps as part of a V1.0.0.1 bug, in which case, a reboot followed by a reinstall of the TDS GTNXi by running the TDS GPS Manager as an administrator would always solve this issue, but we are glad that all is sorted!